[PATCHV2 1/3] ath10k: move firmware_swap_code_seg_info to ath10k_fw_file

[Valo, Kalle]

<c_traja at qti.qualcomm.com> writes:

> From: Tamizh chelvam <c_traja at qti.qualcomm.com>
>
> Preparation to make use of firmware_swap_code_seg_info for
> UTF binary.
>
> Signed-off-by: Tamizh chelvam <c_traja at qti.qualcomm.com>

This patchset crashes my x86 laptop once I start hostapd. Unfortunately
I can't provide any logs as I don't have netconsole set up yet, but this
is the board I'm using:

[   58.481559] ath10k_pci 0000:02:00.0: pci irq msi oper_irq_mode 2 irq_mode 0 reset_mode 0
[   58.633122] ath10k_pci 0000:02:00.0: qca988x hw2.0 target 0x4100016c chip_id 0x043202ff sub 0000:0000
[   58.633126] ath10k_pci 0000:02:00.0: kconfig debug 1 debugfs 1 tracing 1 dfs 0 testmode 1
[   58.633318] ath10k_pci 0000:02:00.0: firmware ver 10.2.4.70.52 api 5 features no-p2p,raw-mode,mfp crc32 67c4d25c
[   58.690098] ath10k_pci 0000:02:00.0: board_file api 1 bmi_id N/A crc32 bebc7c08
[   59.950554] ath10k_pci 0000:02:00.0: htt-ver 2.1 wmi-op 5 htt-op 2 cal otp max-sta 128 raw 0 hwcrypto 1

-- 
Kalle Valo