Issue with ATH10K driver while bringing up mesh interface

[Horse]

Hi
Which firmware version are you using now?
I think "RAW" mode is disabled after firmware 10.4 no matter CT firmware 
or official firmware.
if you are using firmware 10.2, you might need to add rawmode=1 while 
insmod ath10k_core.ko

Thanks

Sridhar Kondabathini 於 2016/8/16 下午 12:06 寫道:
> Hi,
>     When we are trying to bring up AP to add mesh interfaces on T1024 board with
> kernel-3.12; ath10k drivers backported from 4.4;hostapd 2.5 for 11AC support is
> used, then we are getting below error -
>
> ----------------------------------------------------------------------------------
>
> T1024# ifconfig mesh0
>
> mesh0     Link encap:Ethernet  HWaddr 04:f0:21:1b:7d:b6
>            BROADCAST MULTICAST  MTU:1500  Metric:1
>            RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>            TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>            collisions:0 txqueuelen:1000
>            RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)
>
> T1024# ifconfig mesh0 0.0.0.0 up
>
> [ 8694.385554] ath10k_pci 0001:03:00.0: must load driver with rawmode=1 to add mesh
> interfaces
>
>
> ----------------------------------------------------------------------------------
>
> How to resolve this issue, can you please help on this.
>
>
> Regards,
>
> Sridhar Kondabathini,
> Research engineer,
> PSG lab,
> Center for Development Of Telematics
> 9480484821.
>
>
>
>
> Disclaimer:
> ----------
> This email and any files transmitted with it are confidential and intended solely
> for
> the use of the individual or entity to whom they are addressed.  If you are not the
> intended recipient you are notified that disclosing, copying, distributing or taking
> any
> action in reliance on the contents of this information is strictly prohibited. The
> sender does not a
>
>
> _______________________________________________
> ath10k mailing list
> ath10k at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/ath10k