[PATCH v2] ath10k: remove VHT capabilities from 2.4GHz

[Krishna Chaitanya]

On Wed, Apr 27, 2016 at 1:40 AM, Ben Greear <greearb at candelatech.com> wrote:
> On 04/26/2016 01:07 PM, Krishna Chaitanya wrote:
>>
>> On Tue, Apr 26, 2016 at 5:33 PM, Valo, Kalle <kvalo at qca.qualcomm.com>
>> wrote:
>>>
>>> Johannes Berg <johannes at sipsolutions.net> writes:
>>>
>>>> On Thu, 2016-04-21 at 08:15 -0700, Ben Greear wrote:
>>>>
>>>>> The thing is, it actually works just fine with the patch I posted
>>>>> to fix mac80211, and at any rate, even if the mac80211 patch isn't
>>>>> applied, the ath10k driver works just fine in HT mode.
>>>>
>>>>
>>>> This patch has no implications on HT, and I wasn't planning on applying
>>>> the mac80211 patch.
>>>
>>>
>>> Yeah, makes sense. I'm planning to apply this soon.
>>>
>>>> As I said, I have no objections to doing the (Broadcom) vendor specific
>>>> IEs for "VHT" in 2.4 GHz band, but I don't think we should advertise
>>>> the spec IEs when they're explicitly specified to be used only in the
>>>> 5.2 GHz band.
>>>
>>>
>>> But we really should have this, any volunteers? :) I think it shouldn't
>>> be too hard to do so this would be a good project for someone looking
>>> for a simple, but useful, task on wireless stack.
>>
>> Are these Broadcom IEs documented somewhere? If yes,
>> then its a matter of parsing them and adding support to
>> minstrel_ht, isn't it? major work would be in minstrel.
>>
>
> For ath10k, rate-ctrl is done in the firmware, so
> no work at all in minstrel-ht.

Right, i think this might become more common.
So may we need to change minstrel_ht as well?

> The end result, as far as I can tell,
> is you would just have to tell mac80211 to allow
> VHT on 2.4Ghz, and revert this patch that Kalle is proposing.

Ideally as this is vendor specific it makes sense to implement this
at Driver/FW level rather than implementing it at a common stack
like mac80211.

> Maybe someone that actually knows about these IEs can explain why
> they are worth using?

These IE's can be parsed in the driver without any mac80211 involvement.