[PATCH 1/2] ath10k: change beamformee VHT STS capability

[Bartosz Markowski]

On 2 September 2015 at 15:55, Kalle Valo <kvalo at qca.qualcomm.com> wrote:
> Bartosz Markowski <bartosz.markowski at tieto.com> writes:
>
>> On 28 August 2015 at 14:56, Bartosz Markowski
>> <bartosz.markowski at tieto.com> wrote:
>>> On 27 August 2015 at 14:47, Michal Kazior <michal.kazior at tieto.com> wrote:
>>>> From: Bartosz Markowski <bartosz.markowski at tieto.com>
>>>>
>>>> All beamformee supporting chips have the ability to support
>>>> VHT NDP in up to 4 STSs. Change the published beamformee
>>>> STS cap accordingly to 3 as it should be Nsts-1.
>>>>
>>>> This makes it possible to actually make full use
>>>> of. e.g. a 4SS MU-MIMO capable AP.
>>>>
>>>> Signed-off-by: Bartosz Markowski <bartosz.markowski at tieto.com>
>>>> Signed-off-by: Michal Kazior <michal.kazior at tieto.com>
>>>> ---
>>>
>>> Kalle, please drop this one for now. It looks like we need to discuss
>>> about this a bit more still.
>>
>> I have sent a follow up on this, splitting it into 2 patches (vht nsts
>> and sounding dimensions), addressing the concerns raised about the
>> lack of firmware passing the needed bits in vht_cap_info.
>
> Ok, patch 1 dropped. I assume patch 2 is still valid.

correct.

-- 
Bartosz