[PATCH 2/2] ath10k: set peer MFP flag in peer assoc command

Kalle Valo kvalo at qca.qualcomm.com
Sat Oct 31 02:38:17 PDT 2015

<c_traja at qti.qualcomm.com> writes:

> From: Tamizh chelvam <c_traja at qti.qualcomm.com>
> Set peer's management frame protection flag in peer assoc command,
> this setting will enable/disable encrytion of management frames in fw.
> Setting of this flag is based on whether MFP is enabled/disabled at STA
> and a firmware feature flag ATH10K_FW_FEATURE_MFP_SUPPORT. This is because
> only firmwares 10.1.561 and above have support for MFP.
> Signed-off-by: Tamizh chelvam <c_traja at qti.qualcomm.com>
> Signed-off-by: Manikanta pubbisetty <c_mpubbi at qti.qualcomm.com>

There was a trivial conflict, please check my conflict resolution in the
pending branch:


Kalle Valo

More information about the ath10k mailing list