Support for QCA6174 [168c:003e]
michaelkrupp at gmx.net
Tue Oct 27 04:22:05 PDT 2015
yes, I checked the actual performance via netcat, scp and rsync. I'll report
back once I have tested against another AP.
On 10/27/2015 07:22 AM, Michal Kazior wrote:
> On 26 October 2015 at 22:18, Michael Krupp <michaelkrupp at gmx.net> wrote:
>> I managed to get it (sort of) working with the eeprom extracted from the
>> driversand thefirmware from kvalo's ath10k-repo on GitHub.See more details
>> Unfortunately I only get a bandwidth of about 2Mb/s connected to a 54Mb/s
>> this a known limitation to ath10k right now, or may there be a way to get it
>> working at full speed?
>> Also, thank You Michał for pointing me the right direction and helping make
>> usable, at least.
>> # iwconfig wlp7s0:
>> wlp7s0 IEEE 802.11abgn ESSID:"[REMOVED]"
>> Mode:Managed Frequency:2.457 GHz Access Point: 00:24:FE:A8:2C:55
>> Bit Rate=1 Mb/s Tx-Power=20 dBm
>> Retry short limit:7 RTS thr:off Fragment thr:off
>> Encryption key:off
>> Power Management:on
>> Link Quality=69/70 Signal level=-41 dBm
>> Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
>> Tx excessive retries:0 Invalid misc:32 Missed beacon:0
> Did you actually check the performance? The driver doesn't report tx
> rate properly due to firmware limitation so it always reports 1mbps or
> 6mbps to userspace tools.
> Sidenote: `iwconfig` is deprecated. `iw` is the go-to wireless tool now.
> ath10k mailing list
> ath10k at lists.infradead.org
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 819 bytes
Desc: OpenPGP digital signature
More information about the ath10k