[PATCH 1/3] ath10k: reset chip before reading chip_id in probe

Kalle Valo kvalo at qca.qualcomm.com
Tue Jan 27 06:02:19 PST 2015

Michal Kazior <michal.kazior at tieto.com> writes:

> There are some very rare cases with some hardware
> configuration that the device doesn't init quickly
> enough in which case reading chip_id yielded 0.
> This caused driver to subsequently fail to setup
> the device.
> Signed-off-by: Michal Kazior <michal.kazior at tieto.com>

Thanks, all three patches applied to ath.git.

Kalle Valo

More information about the ath10k mailing list