Getting a 'no-ack' tx status?
greearb at candelatech.com
Fri Feb 27 15:26:15 PST 2015
Someone reported to me that they never see the
tx_done->no_ack flag set on their AP, even when stations are falling
off the network due to not receiving ACKs.
info->flags &= ~IEEE80211_TX_STAT_ACK;
I am having no luck finding the corresponding code in the 10.1.467
firmware that would cause this to work, but maybe I am just not looking
in the right place.
Has anyone done any testing to see if ath10k actually reports ACK failures
properly back up the stack?
Ben Greear <greearb at candelatech.com>
Candela Technologies Inc http://www.candelatech.com
More information about the ath10k