[PATCH] ath10k: allow Mesh Point to install peer security key

[Kalle Valo]

Peter Oh <poh at qca.qualcomm.com> writes:

> Mesh Point requires peer security key install when running
> in secured mode since it's a type of peer links, otherwise peer
> link will be removed due to key install failure.
>
> MFP feature set is required to run Mesh in secured mode and
> QCA988X firmware, 10.2.4.70.14-2 and above, is the only one
> supporting secured Mesh at this moment.
>
> Signed-off-by: Peter Oh <poh at qca.qualcomm.com>

Applied, thanks.

-- 
Kalle Valo