[PATCH 1/2] ath10k: Support different txbf configuration schemes

Kalle Valo kvalo at qca.qualcomm.com
Thu Aug 13 04:21:38 PDT 2015

Vivek Natarajan <nataraja at qti.qualcomm.com> writes:

> qca61x4 uses the vdev param as a sole sufficient configuration
> for txbf while qca99x0 enables txbf during peer assoc by
> combining the vdev param value with peer assoc's vht capabilities
> This patch gets the appropriate txbf configuration scheme
> before passing the wmi command to enable the same in the firmware.
> Signed-off-by: Vivek Natarajan <nataraja at qti.qualcomm.com>

Thanks, both patches applied.

Kalle Valo

More information about the ath10k mailing list