[PATCH] ath10k: Add QCA99X0 to supported device list

[Felix Fietkau]

On 2015-08-06 09:43, Vasanthakumar Thiagarajan wrote:
> On Wednesday 05 August 2015 05:51 PM, Felix Fietkau wrote:
>> On 2015-07-21 13:36, Vasanthakumar Thiagarajan wrote:
>>> Add vendor/device id of QCA99X0 V2.0 to pci id table and
>>> QCA99X0_HW_2_0_CHIP_ID_REV to ath10k_pci_supp_chips[] for
>>> QCA99X0 to get detected by the driver.
>>>
>>> Signed-off-by: Vasanthakumar Thiagarajan <vthiagar at qti.qualcomm.com>
>> I just tested a 99X0 card, and I'm getting this:
>>
>> [    8.742514] ath10k_pci 0000:01:00.0: enabling device (0140 -> 0142)
>> [    8.747173] ath10k_pci 0000:01:00.0: pci irq msi interrupts 1 irq_mode 0 reset_mode 0
>> [   11.793314] ath10k_pci 0000:01:00.0: failed to receive initialized event from target: 00000000
>> [   11.793344] ath10k_pci 0000:01:00.0: failed to wait for target after cold reset: -110
>> [   11.800814] ath10k_pci 0000:01:00.0: failed to reset chip: -110
>> [   11.809228] ath10k_pci: probe of 0000:01:00.0 failed with error -110
>>
>> This is on an AP148 board with Linux 3.18, backports generated from
>> latest wireless-testing (2015-08-03) + all patches from kvalo's ath
>> tree.
> 
> Any idea about the version of AP148 that you are using?. By any chance did
> you check if QCA988X is working on the same board?.
No idea about the version, but QCA988X is working in the same slot.

- Felix