michal.kazior at tieto.com
Thu Apr 30 03:50:22 PDT 2015
On 30 April 2015 at 12:31, Yeoh Chun-Yeow <yeohchunyeow at gmail.com> wrote:
> Hi, Michal
>> I assume you need to reboot the machine before it starts to work
>> again, no? Or does driver reload alone help?
> The system looks very sluggish once the firmware start to crash. But
> not required reboot.
I assume it's due to crash-restart going over and over which involves
taking RTNL - this could reduce system responsiveness.
>> Did you try to `echo 1 >
>> /sys/bus/pci/devices/xxxx:xx:xx.x/remove` and `echo 1 >
>> Or did you try to swap fw from 10.2 to 10.1
>> (needs driver reload) after the "bad bad crashes" start to appear?
> I try to load 10.1 after the firmware crashed on 10.2 and it is
> working. See log below.
> So no changes at all for this board to use 10.2 firmware?
Did you try to reload the driver alone (without changing firmware)?
I'd like to know if it's actually 10.2 -> 10.1 that makes the crashing
More information about the ath10k