[PATCH v2 2/2] ath10k: implement more versatile set_bitrate_mask

[Kalle Valo]

Michal Kazior <michal.kazior at tieto.com> writes:

> On 31 March 2015 at 12:49, Michal Kazior <michal.kazior at tieto.com> wrote:
>> Until now only a single fixed tx rate or nss was
>> allowed to be set.
>>
>> The patch attempts to improve this by allowing
>> most bitrate masks. The limitation is VHT MCS
>> rates cannot be expressed separately and only the
>> following VHT MCS ranges are supported: none, 0-7,
>> 0-8, and 0-9.
>>
>> This keeps the old behaviour when requesting
>> single tx rate or single nss. The new bitrate mask
>> logic is only applied to other cases that would
>> return -EINVAL until now.
>>
>> Depending on firmware revisions some combinations
>> may crash firmware so use with care, please.
>>
>> Signed-off-by: Michal Kazior <michal.kazior at tieto.com>
>> ---
>
> Hi Kalle,
>
> Drop this patch ([2/2]) for now, please. It looks like it doesn't work
> well with crypto networks. I'll need to rework this. The [1/2] is fine
> as it is though.

Ok, patch 2 dropped.

-- 
Kalle Valo