[PATCH v3] ath10k: support get/set antenna configurations.

[Avery Pennarun]

On Wed, May 14, 2014 at 2:20 AM, Yeoh Chun-Yeow <yeohchunyeow at gmail.com> wrote:
> I try to test by setting of antennas in my AP (firmware version
> 10.1.467.2-1) using ath10k to the following:
>
> iw phy0 info | grep Antennas
> Available Antennas: TX 0x7 RX 0x7
> Configured Antennas: TX 0x1 RX 0x1
>
> But my STA (using ath10k) seems to get the same throughput even with
> single tx and rx antenna.

What throughput are you getting, and what is the signal strength?