[PATCH] ath10k: fix aggregated 4addr Rx

[Ben Greear]

On 07/31/2014 08:49 AM, Vu Hai NGUYEN wrote:
> Thank you for the patch. I applied it (manually not automatically, the patch is not based on ath-master branch?)
> The warning msg: br0: received packet on wlan0.sta1 with own address as source address disappeared on the console of my AP.
> But the performance of my bridged STA (using CT firmware) is still lower than non-bridged STA (10.1-467 firmware).
> (520 vs 550 Mbps)
> 
> The processor of my AP is not exhausted (about 15-20% idle) but perf top on my bridged STA show that there is this thread: br_fdb_update.
> I didn't see it on non-bridged STA, it takes 5% resource of the processor
> I look for it on google and this thread is related to the warning message br0:received packet on wlan0.sta1 with own address as source address
> Do you guy have any suggestion?

Is there any way at all to make the standard firmware do bridged mode?  I am curious if
the slow-down is due to my firmware or to bridging in general...

Thanks,
Ben

-- 
Ben Greear <greearb at candelatech.com>
Candela Technologies Inc  http://www.candelatech.com