[PATCH] ath10k: configure access category for arp

[Marek Puzyniak]

On 29 January 2014 14:14, Kalle Valo <kvalo at qca.qualcomm.com> wrote:
> Marek Puzyniak <marek.puzyniak at tieto.com> writes:
>
>> ARP frames exchange does not work properly for UAPSD enabled AP.
>> ARP requests which arrives with access category 0 are processed
>> by network stack and send back with access category 0. FW changes
>> access category to 6. This is causing problems when UAPSD associated
>> STA is sleeping after has sent ARP request. Configure ARP access
>> category in FW to best effort (0) solves this problem. ARP frames
>> will be send with access category 0.
>>
>> Simplify arp ac override functionality by removing redundant entry in
>> pdev param maping table. There should be only one entry in pdev param
>> map but enum has different name for different FW.
>>
>> Signed-off-by: Marek Puzyniak <marek.puzyniak at tieto.com>
>
> I had a conflict when I applied this to ath-next-test. Please check that
> I didn't break anything:
>
> https://github.com/kvalo/ath/commit/2e006642b3aad6a5fb91f9e560a2bbcdf74aa049
It looks ok.
>
>> +     ret = ath10k_wmi_pdev_set_param(ar,
>> +                                     ar->wmi.pdev_param->arp_ac_override, 0);
>> +     if (ret) {
>> +             ath10k_warn("could not init WMI_PDEV_PARAM_ARP_AC_OVERRIDE (%d)\n",
>> +                         ret);
>
> I also modified this warning message to follow the style used elsewhere
> in the driver.
>
> --
> Kalle Valo