BAR error, failed to get chip id.

[Ben Greear]

I see this fairly often on module reload.  Firmware is modified
by me, based on 10.1.389, so if there are firmware fixes since then
that address this problem I would not know of it.  Kernel is ath-testing,
with some local changes, but nothing pertaining to the pci code.


Kernel 3.13.0-rc8-wl-ath+ on an x86_64 (ttyS0)

ct523-9292 login: ath10k_pci 0000:05:00.0: BAR 0: error updating (0xf4400004 != 0xffffffff)
ath10k_pci 0000:05:00.0: BAR 0: error updating (high 0x000000 != 0xffffffff)
ath10k: Failed to get chip id: -110


After this, it takes a power cycle to get the system working again.

Anyone seen similar?

Thanks,
Ben

-- 
Ben Greear <greearb at candelatech.com>
Candela Technologies Inc  http://www.candelatech.com